[ Pobierz całość w formacie PDF ]
.SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV.00www.cobra.itXMAKEHONDAMOD.CR-VYEAR97 → PETROLDIESELALARM/SIRENPosition the compact alarms and the sirens in the engine compartment, on the support POSITIONpanel at the shock absorber, driver’s side.Position the modular systems and the modules under the dashboard, driver’s side.POWER SUPPLY+ 30: connect to the general supply wiring in the fuse box.- 31: connect to the car body.IGNITION WIRE+ 15/54: connect to the 0,5 mm2 YELLOW/RED wire with GREY reference located in the wiring harness coming out of the 24 way light blue connector above the fuse box.DIRECTION INDICATORSConnect to the 0,75 mm2 GREEN/YELLOW wire with GREY reference and to the GREEN /RED wire with GREY reference located in the wiring harness of the 6 way connector, in the front part of the fuse box.ELECTRIC WINDOWSPositive control signalFront window, driver’s side:cut the 1,5 mm2 RED/BLUE wire.Front window, passenger’s side:cut the 1,5 mm2 BLUE/YELLOW wire with BROWN reference.Rear window, driver’s side:cut the 1,5 mm2 GREEN/YELLOW wire with BROWN reference.Rear window, passenger’s side:cut the 1,5 mm2 YELLOW wire with GREY reference.These connections should be effected in the wiring harness coming out of the 14 way transparent connector of the control switches.CENTRAL DOORS LOCKINGNegative control signalConnect to the 0,5 mm2 BLUE/RED wire with GREY reference (unlock) and to the 0,5mm2 BLUE/WHITE wire with GREY reference (lock) located in the wiring harness coming out of the 14 way grey/white connector linked to the central doors locking unit, inside the driver’s side door.Refer to the diagram nr.126.IMMOBILISATION POINTFuel pumpCut the 0,5 mm2 YELLOW/RED wire with GREY reference located in the 24 way light blue connector, above the fuse box.STARTER+50: Cut the 2,5 mm2 BLACK/WHITE wire located in the wiring harness coming out of the 3 way brown connector, behind the fuse box.BONNET SWITCHInstall an additional switch on the bonnet bumper, near the original rubber in correspondence of the driver’s side headlamp.DOORS SWITCHConnect to the 0,5 mm2 LIGHT GREEN/RED wire with GREY reference located in the wiring harness coming out of the 20 way grey connector, behind the sill cover, driver’s side.BOOT SWITCHConnect to the 0,75 mm2 BLUE/BLACK wire with GREY reference located in the wiring harness coming out of the 14 way blue connector, in the superior part of the fuse box.Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed hocrv97gbb.docas per the instructions given on the product installation manual.SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV.00www.cobra.itFITTING DIAGRAM N°126Diagram to make the locking and the opening of the doors on HONDA CR-V, HR-V, LOGO(for antitheft with 6 wires locking, with serie Bridge using Art.1044) VIOLET VIOLET/WHITE ORANGE GREY/BLACKYELLOW/BLACK ORANGE/WHITELocking pulseOpening pulseTowards central doors locking unit Towards door motor Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed hocrv97gbb.docas per the instructions given on the product installation manual [ Pobierz całość w formacie PDF ]